www.BoundAnna.com

(M25sis)

Hello,
I have juts bought a new Hismith fucking machine and I am looking to try and create some kind of hands free cum reclycling tube with pump.
or perhaps a reservoir for said fluid to be recycled and pumped back into a gag or squirting dildo.

With my extensive collection of bondage spreaders, ropes, collars and gags I feel I have all of the basics in place.

with loose specifics, the main scenario being-
-Lying on my front or back on the floor with a separate leg shabari close leg tie and my hand handcuffed behind my neck collar /or/ perhaps a ankle to wrist tie with an angle leg spreader.
(obviously dressed in crotchless panties, stocking, sexy fishnet extras x.)

-with my new Hismith fucking machine on med-high power attached to a wall plug timer set to 5 minute on 25 minutes off.
-a wall plug wand set to the same extension cable and taped to the under seller of my sissy cock and balls.

-escape, a basic ice escape or timed safe with key

REQUEST-
to create a solution to collecting all fluids to be redirected to ball gag with a hole in (with said tube going though), even perhaps a shallow catheter. would a small pump of some kind work.

Any and all help will be HUGELY APPRECIATED

Thanks x
F

a small peristaltic pump should do the trick.

I have used one to build a squirting dildo...
Have a look at my last post in this topic: http://forum.boundanna.net/board/viewto ... 12&t=11419

occorics wrote:a small peristaltic pump should do the trick.

I have used one to build a squirting dildo...
Have a look at my last post in this topic: http://forum.boundanna.net/board/viewto ... 12&t=11419

I may have come across one of your comments of a kind of similar post before. good idea I may have to try this with a bottle of fake cum of some sorts, similar to your squirting dildo. Only issue being if I where to use an External Catheter for example with the pump attached to the tube leading to a gag, it would create a vacuum stopping any fluids from coming out and down the tube. I may have tho think up some kind of external reservoir and add a t junction or a small whole in the top of the Catheter to create some kind of flow.

eg, iv tried just a tube with no luck. fail haha

Any ideas?



I Lovveeeeeee your machine, wish I had an owner tho would want to put me in that !

Maybe you can run the pump in short intervals and use a t-junction to create a controlled leakage, just enough to reduce the vacuum a bit while the pump is off.

Or maybe you can put some sort of valve into the line, so that the vacuum would suck air into the tube, but the fake cum can't be pumped out through the wrong hole?
If I remember correctly some other users (tinkerers) had problems when trying to pump too thick fake cum through a dildo. The viscosity seems to be quite a problem.
Maybe you'll have to adjust for that as well?

In any case: good luck and please let us know the outcome of your attempts. Thanks.

Blacky wrote:If I remember correctly some other users (tinkerers) had problems when trying to pump too thick fake cum through a dildo. The viscosity seems to be quite a problem.

That was me... but in my case, the tube through the dildo is very thin (~1mm inside opening). I'm pretty sure 3mm would already be enough. The pump itself can handle the fake cum without a problem...

Have you tried running the tube from your catheter into a small container first, then pumping from the container to your mouth? This should eliminate the vacuum caused by a direct connection from the catheter tube to the pump.

Here's a little pump that seems perfect for the purpose.

Smallish volume, periodic pulses, has a peristaltic pump section to fill it.

https://www.aliexpress.com/item/4000943927079.html

AssTechWarrior wrote:Here's a little pump that seems perfect for the purpose.

Smallish volume, periodic pulses, has a peristaltic pump section to fill it.

https://www.aliexpress.com/item/4000943927079.html

I use a similar one. It works really good actually

Welcome to BoundAnna, stillc

Welcome to BoundAnna, stillc

I suspect the relatively small volume will cause problems with any solution, except perhaps a curled up position that puts your cock pretty much above your mouth coupled with a gravity slide/tube to direct the flow into or above your mouth.

An alternative would be to save a few loads (frozen, I presume) and deliver them via a pump*, triggered with something like a solid state liquid switch by your ejaculation. It still shoots when you do and is still your own cum, just not _this_ cum.

* Or pressurized system, per another recent discussion.

kinbaku wrote:Welcome to BoundAnna, stillc

Shannon SteelSlave wrote:Welcome to BoundAnna, stillc

Thanks