DIY pneumatic fucking machine *video*

[rzyzzy]

You have -
A timer-relay,
a pneumatic valve,
an air cylinder ,
assorted hose fittings,
and a vac-u-lock adaptor...
stuff them all into a cookie-tin...
and you get?
http://www.youtube.com/watch?v=BQ-Mbldn5AU

PM me if you need a parts list...

[bound_jenny]

Three words: House Of Gord.

Welcome to the forum!

Jenny.

[Jadit]

That sounds noisy :p But it works.

[rzyzzy]

Three words: House Of Gord.

Welcome to the forum!

Jenny.

Funny you say that - I posted the vid on Fetlife, and Gord actually popped into the thread...

It is a total ripoff of his original concept - but I figure that anything that inspires the creation of more pneumatic machines is a positive - especially if we get more "in action" pictures posted!

My next step is ditching the timer-relay and replacing it with an Arduino - at that point, the world is your oyster - you have the ability to incorporate computer controls over ethernet or even wirelessly (through an ipod!) , programmed "routines" - the sensor input/output capability gives you a chance to control vibes, magnetic locks, pneumatic "thumpers", "squeezers", spankers, fuckers, electrical stimulation, etc.

FWIW, the self-bondage community seems to be the *most* advanced group out there tech-wise - and I figure if we can inspire a few people to apply that talent, maybe devious fucking machines will be as common as vibrators in future years.

[ponylady]

Funny you say that - I posted the vid on Fetlife, and Gord actually popped into the thread...

that guy pops up in quite some forums.
that's why i so admire his "labor of love"

i have to get my copies of HOG-mags from the early 90's signed by him one day.

[Kronopticon]

fetlife? look me up! ^-^ i wish i had the skills to make something like this, but sadly not.... house of gord will forever amaze and gobsmack me, amongst other sensations

[nitrox]

Looking at your youtube page, isn't this actually a 4 way valve?

[fs13]

Can you give details on the relay please

[rzyzzy]

Just updating the thread - I built a chair using generic kee-klamp fittings & 1.5" schedule 40 steel pipe. I'm using an Arduino Nano as a controller, using the "blink" sketch as a timer. I have a 10K pot to adjust the speed, and a "relay cube" off Ebay to actuate a 12volt, 5port-2 position pneumatic valve. The pneumatic valve is hooked to a 3/4" cylinder, with a 4" stroke.

Here's a video of it in action -

http://youtu.be/-m6D_ImbA6U