I took a test today from 6am to 9am.
With the following settings:
Maximum strength on channel B at 150 (only channel B of the DG-lab was connected with my elastic bands around the penis).
Initial delay 9 sec
phase 1 delay 2 sec
phase 1 Intense switch 40
phase 2 delay 10 sec
phase 2 Intense switch 60
phase 3 delay 20 sec
phase 3 Intense switch 80
phase 4 at max 120 sec
phase 5 before recycle 1 sec
end tour 60 minutes
The Initial and phase 5 short because I wasn't tied down.
With the following patterns, successively with the first 4 only run through once (after phase 5 each time changed pattern) and the last pattern until the hour had ended:
- No Pattern
- Moan softly~ by Leetthief (4m05s)
- Intense milking by Firefox93 (2s)
- CruelMilkman-Vol5 by Geo Cyberwolf (5m2s)
- Pump-it-Up V2 by Kapron (with all sliders moved to the left in DG-Lab's screen).
In the last pattern I also blindfolded myself and connected my Gemini to my nipples.
I suspect that the switch happens at the percentages (here 40%, 60%, 80%). When using a Pattern, this is not always correct - probably because the pattern itself goes over that percentage at the right time, so that you get to the next phase sooner.
But if you know that, it's not so bad.
The same thing happens that he moves forward 2 steps at once instead of only 1 step, probably due to rounding differences.
An improvement could be - but I don't know if this is possible with xtoys.app programming - that the Initial delay is only played the first time and that it immediately switches to "phase 1 delay" after the "5th phase".
Then phase 1 can really serve to get you ready: handcuffs on, switch on other devices, blindfold on, pull on the ratchets and wait in suspense when the program starts.
All in all pleasurable moments for 3 hours with gentle stimulation, edging, orgasm, milking, torture.