Amordaza wrote:Is there a particular gag you'd like me to use for this dare?
A slightly more extensive explanation of the wrist rope binding that I use a lot:
- tie the ends together by just gathering the ends together and make an overhand knot with both ends
- put your left hand in this loop so that the knot is on the back of your wrist
- bring your wrists together with the palms of your hands inside
- wrap both ropes of the loop around your right wrist
- then between your wrists
- then in the opposite direction around your left wrist
- then again between your wrists - if you look at it from above you have made a figure eight with the two ropes of the loop
- continue in this way, each time around the right wrist, between the wrists, around the left wrist and back between the wrists. Until you have about 30 cm (12") left
- twist this twice around the middle of the figure eight between the wrists to form a light cinch
- then put the loop over one wrist until it is completely past the bindings around that wrist.
If I always want to free myself, I'll stick with this, I just have to reverse the movements and I'm free again.
However, if you want to block the binding with a padlock, you just have to fasten this last loop to some of the lower loops that are wrapped around your wrist. This makes it impossible for you to get this last loop back over your hand to free yourself.
- 8FormCuffs.jpg (21.07 KiB) Viewed 4872 times
If you don't want the backup of the knot on the back of your hand, you can initially position it so that it comes between your wrists.
In the end it is therefore hidden under the 2 cinching loops and therefore inaccessible to your hands.
Regarding your gag:
I don't know how big your rings are, but put 3 or 4 on top of each other and tie them together with a prusik knot. If necessary, place another turn in it - the same as making a prusik from a lark's head - so that there are a total of 6 turns around the rings and they are well on top of each other (see on the right in the drawing).
Make a loop the size of your head and twist the rope several times around the other side of the ring (left in the drawing).
Pop this homemade ring gag in your mouth and pull the rope until it is on. Optionally you can put the ends of the rope between the loop around your head and pull it so that the loops on the left side of the rings are pulled together (Not shown in the drawing so as not to overload it). Thus it goes in your mouth behind the rope that is around your head and goes into the rings.
Then make a slip knot with the ends and stretch it to the back (at the top of the drawing) - you can use a Tautline hitch instead of this simple overhand knot in the picture.
- RinggagDIY.jpg (19.82 KiB) Viewed 4872 times
If the rings are too big, put some square knots in the middle of your bandana and put those knots in your mouth and tie the bandana behind your head.