Thumb cuffs & ball clamp from kiddie locks

Ideas and instructions how you can make your own bondage toys.
Post Reply
MSpike
**
Posts: 102
Joined: 20 Nov 2014, 15:42

Thumb cuffs & ball clamp from kiddie locks

Post by MSpike »

The long U-shaped plastic locks used to toddler-proof cabinets can be turned into clamps for other things with InstaMorph heat-moldable plastic, or other self hardening materials.
zkidlocks1.jpg
These are the original locks. Note the release tabs on the side away from the ratchet teeth - squeeze them to release the lock.

Adding plastic to the ends thickens and shapes the clamping part. Be careful not to block the ratchet teeth or stick the moving part to the rails.
zkidslock2.jpg
The upper device is a ball clamp with a cock ring in the movable part. There's also an attachment ring on the fixed end, with a ring device tied to it.

The lower device is a thumb (or big toe, cock and balls, etc.) cuff. The middle part slides freely. Large diameter drinking straws were slid over the rails of the lock, then the InstaMorph was molded over them, so it didn't stick to the rails. There's also an attachment ring at the fixed end, but one could be molded into the middle part also.

This particular setup clamps on the balls, the ropes go through a groove in the butt plug, and attach to the thumb cuff. After the cuff is closed tightly with hands behind you, pull the free end of the ropes to tighten everything. Locking: form a wedge that goes in the slot on the movable end, so it holds the release handles apart. Escape: Put the thumb nearest the movable part through from the side with the release tabs, and squeeze them with first two fingers to loosen the ratchet. It's not easy, so try it with hands in front and pliers or a wire-cutter handy. You might also mold on larger tabs.

Build or modify, and enjoy,
Mar Lingspike
Post Reply