the inquisitor seat

Ideas and instructions how you can make your own bondage toys.
Post Reply
User avatar
Dark_Lizerd
*****
Posts: 2416
Joined: 22 Oct 2006, 11:30
Location: New Mexico

the inquisitor seat

Post by Dark_Lizerd »

A torture device that I'm sure Claudia will be building next weekend...
Simple idea:
Version 1:
The "user" is tied to a chair, but there is enough slack for the user to
rise up, some, but will tire quickly, and that is the point...
The seat is placed on, preferably, wooden seated chair, or, it could be
the chair itself, and a "U" shaped seat is provided that will raise the
user above this seat. Once everything is in place, user tied to the chair,
the "U" seat slowly lowers, the user onto the but plug and the
pussy rubbing torture ramp. This could just be from a slow leaking valve,
or in steps when the "inquisitor" gets answers he does not like.
The back brace keeps the user's ass and back from moving back due to the
push from the pussy ramp. The ramp is positioned so that at the start, it
presses against the pussy, then, as the user is lowered, the copper tubing
slides into the outer pussy lips then starts to pull them open exposing the
inter lips. (A female test subject would be needed to verify that this will
Really happen...)

When the user finally "lands" on the bottom, she will press the 2 contacts to,
A) start the vibrator, located to be firmly pressed against the tender,
sensitive parts of the pussy. (the pleasure part)
B) Start the TENS unit that one channel is connected to one of the copper
tubes and the metal outside of the vibrator.
The other channel is connected to the other copper tube, both tubes could
also be connected together, and the switch plates under the ass.
If a tapered butt plug is used, when the user hits bottom, she would be stuck,
and the next part will not happen.
Now, with the shocks, the user will try to rise up, which could allow her
to get off the contacts, but with out some way to stay up, the muscles will
tire, and the user will slide back down. Up and down, getting an ass fuck
with every attempt until she is unable to rise up again and then will just be
stuck there, with the vibrations and shocks going to the pussy, there will be
no escape...

Version 2:
Same as above, but the user is strapped down to the chair, unable to move,
and the inquisitor seat is raised up into place from underneath.

Also, the butt plug could be conductive and place the shocks there instead
of the ass. Or both.

So, who will be the first to build and test this???
Inquisiter's seat.jpg
All advice is checked, re-checked and verified to be questionable...
Don't ask, we both wont understand the answer...
http://www.mediafire.com/download/09dtr ... e_V2_2.exe Not just for nubies any more...
User avatar
bound_jenny
Moderator
Posts: 10268
Joined: 09 Dec 2007, 12:37
Location: Montreal, Canada, Great Kinky North

Re: the inquisitor seat

Post by bound_jenny »

The perfect Christmas gift for the person who already has everything! :mrgreen:

DL, your mind is genuinely twisted. :D :hi:

Jenny.
Helplessness is a doorway to the innermost reaches of the soul.
If my corset isn't tight, it just isn't right!
Kink is the spice of life!
Come to the Dark Side - we have cookies!
Qurat
**
Posts: 82
Joined: 21 Jan 2015, 05:18

Re: the inquisitor seat

Post by Qurat »

So tempted to build one, fortunately I don't have enough time.. :twisted:
Its 50% painless- it doesnt hurt me at all!
johns1234
*
Posts: 45
Joined: 22 Dec 2015, 01:32

Re: the inquisitor seat

Post by johns1234 »

Another way to do this (just to expand on the idea ;)) :

Same setup:
- a board or chair with a chain attached to each corner
- the ends of the chains are linked to a belt
- a dildo mounted in the middle
Mount on the dildo and tighten the belt around your waist, so you can rise up and down.

Using the blowjob trainer software in this forum (with different sounds): The camera is placed to see the dildo and only two spots needs to be chosen for in the BJ trainer for detection as deep throat isn't needed. Set it up to give enough time between "sucks" and a respite phase too. Place two TENs unit pads on the butt cheeks and let the software activate it if you stop fucking the dildo to punish you. Now you lock yourself up and have to watch yourself being penetrated by the dildo when riding it or get shocked.
You could call it a "ride trainer" 8)
User avatar
Dark_Lizerd
*****
Posts: 2416
Joined: 22 Oct 2006, 11:30
Location: New Mexico

Re: the inquisitor seat

Post by Dark_Lizerd »

I did have another option...
As it is set-up, when you land on the bottom, you get the full shock all at once...
no warning, no way to prepare... all at once and, hopefully, you will be stuck with
no way to escape it...

Here is the option, and it will only work with a conductive but plug, unless you use the contact pads...
Add a linear variable resistor connected to the seat level. As the seat goes down, the shocks will
increase until you hit bottom where it will be at its maximum...
That way, you will have a reason to try and prevent yourself from hitting bottom.
One way to set a minimum and maximum shock level is with 3 resistors...
(Warning... bad ASCII art imitation following...)

GND--- low pot--- slider--- high pot---- Tens output...
..........^-------^....^...........^------^
........................|...................
................. Shock output.......

That way, the least you will be shocked is what the low pot is set at...
and the highest is where the high pot is set...
Altho, you could skip the high pot and set the TENS to the highest you want to be shocked at...
(And then "accidently" bump it a bit higher... :twisted: )
All advice is checked, re-checked and verified to be questionable...
Don't ask, we both wont understand the answer...
http://www.mediafire.com/download/09dtr ... e_V2_2.exe Not just for nubies any more...
Claudia
**
Posts: 151
Joined: 24 Feb 2012, 18:44

Re: the inquisitor seat

Post by Claudia »

So Liz... what make you think I don't already have one of these???

lol.. well not exactly, but similar principle, shocking pain when my muscles get tired...

I'm not sure your chair device will actually work, but I'll probably try to get together a prototype.

Claudia
User avatar
Dark_Lizerd
*****
Posts: 2416
Joined: 22 Oct 2006, 11:30
Location: New Mexico

Re: the inquisitor seat

Post by Dark_Lizerd »

Well, It was a thought, but...
I don't have the "right parts" to try and test this...
Looking at some of my other pictures, I found this one that is just a bit similar...
P47.jpg
P47.jpg (12.53 KiB) Viewed 5020 times
All advice is checked, re-checked and verified to be questionable...
Don't ask, we both wont understand the answer...
http://www.mediafire.com/download/09dtr ... e_V2_2.exe Not just for nubies any more...
Post Reply