Humbler Hogtie Rig

Ideas and instructions how you can make your own bondage toys.
Post Reply
MSpike
**
Posts: 102
Joined: 20 Nov 2014, 15:42

Humbler Hogtie Rig

Post by MSpike »

The DIY humbler can be used as a base for a hogtie setup. The basic setup is a Rope Ratchet (or ring device) with the cord circling from the bottom of the humbler U-bolt between the ankles, up between the wrists, and back to a ring/ice bag release at the bottom of the U-bolt. Details: The ice bag is a small homemade nylon bag with 3/16 in. cord sewed around it, like a mini shopping bag. It holds 1 to several ice cubes, depending on size and shape, good for about an hour, depending on the size of the ring that it has to fit through. Rope Ratchet - this is the size that uses 1/8 in. rope. The 1/4 in. rope size would work, or a double ring device. Wrist and ankle ties - these are strips of "flour sack" kitchen towel cut into 4-5 in. strips and sewed at the ends. They are cheap and don't leave distinct ligature marks. Putting wrists or ankles through in opposite directions, then twisting them parallel forms tight enough loops, or you can twist them again if necessary - experiment. Once the circling cord is pulled tight you won't be able to untwist and escape. Or run the cord between your own cuffs, etc. It should slide over the cuffs, NOT across your skin.
Hogtie Setup Small.jpg
Setup: the humbler bar should be IN FRONT of your legs, where it will hold the tension of the hogtie, and I put the U-bolt around both cock and balls. Tie the loose end of the ratchet cord around the part that forms the circle, so you can find it behind your back. The loose end should go first between the ankles, then up where the wrists will be (much easier to tighten that way). Add ice to the bag and make sure the knots are through the ring. Add any extras, a butt plug works well with this setup, the cord pushes it in tightly. Choose your position: kneeling, face down and face up all work, but the humbler bar will keep you from rolling over and make falling forward or backward uncomfortable. Check your emergency release, fasten your wrists with the ratchet cord between them, make sure the cord runs freely from ratchet, around ankle and wrist cuffs, to release, and pull the loose end. Enjoy.

Alternative base: for those who don't like the humbler, here's an alternative base for attaching the ratchet and ice bag release. The rope V goes in front, or the ladies can just use a wide strap.
AltBase Small.jpg
Mar Lingspike
tiemeupalso
****
Posts: 732
Joined: 19 Sep 2009, 19:03
Location: cameron/rockdale,tx
Contact:

Re: Humbler Hogtie Rig

Post by tiemeupalso »

i pic of it in use would be nice.
User avatar
Sir Cumference
Moderator
Posts: 1608
Joined: 29 Jan 2012, 22:00
Location: Scandinavia

Re: Humbler Hogtie Rig

Post by Sir Cumference »

tiemeupalso wrote:i pic of it in use would be nice.
and probably against the forum rules.....
~ Leatherworking, blacksmithing , woodworking and programming are the most pervertable skills you can learn! ~
MSpike
**
Posts: 102
Joined: 20 Nov 2014, 15:42

Re: Humbler Hogtie Rig

Post by MSpike »

hog drawing_small.jpg
Here's a sketch that should pass the moderators. A photo would show too much anatomy and not much of the function.
tiemeupalso
****
Posts: 732
Joined: 19 Sep 2009, 19:03
Location: cameron/rockdale,tx
Contact:

Re: Humbler Hogtie Rig

Post by tiemeupalso »

ok thanks,good idea.
Post Reply