DIY open mouth gag w/ plug

Ideas and instructions how you can make your own bondage toys.
Post Reply
hykez87
*
Posts: 2
Joined: 29 Apr 2014, 14:51

DIY open mouth gag w/ plug

Post by hykez87 »

A recent project of mine made with easily accessed items.
Image
Image

Materials needed:
-flip cellphone 4" or 5" cover (the board should be made of plastic)
-10 or more liter water bottle (test first if "it" fits)
-old bag strap
-velcro
-post screw
-drain plug with chain (should be enough to fit the mouth of bottle)

Procedure:
1.) Saw off the mouth of the water bottle (after where the cap stops) and smooth out the edges.
2.) Cut off the front of the cellphone cover.
3.) Trace the bottle mouth on the cellphone cover and cut out the hole.
4.) Insert the bottle mouth through the hole. The one with the twists is the one that goes inside your mouth.
5.) Measure the bag strap around your head.
6.) Once you got the measurements, cut the bag strap near the end with the metal buckle and sew the edge. Note: Make sure that the this strap is not too long or too short.
7.) Do the same with the other strap with your desired adjustable length.
8.) Sew velcros on the other strap (the one without the buckle) for added restriction.
8.) Punch holes on both sides of the cover based on the width of the straps.
9.) Using the post screws, attach the straps to the cover. Leave one, where you plan to put the chain of the plug.
10.) Put the other end of the chain to the hole and attach to the cover together with the strap.

And you're done!

The gag is really effective, you can't close your mouth nor push out the gag and you drool a lot.

Feel free to ask any questions.
Last edited by hykez87 on 30 Apr 2014, 01:26, edited 1 time in total.
gemt
***
Posts: 313
Joined: 01 Nov 2012, 17:04
Location: East Anglia

Re: DIY open mouth gag w/ plug

Post by gemt »

Looks good!
I can't help thinking that if I could think of the right bottle then cut the bottom off it,
then you could put the thread on the outside, have more depth on the inside, and use the screw top to close.
Perhaps some cosmetic pot?
hykez87
*
Posts: 2
Joined: 29 Apr 2014, 14:51

Re: DIY open mouth gag w/ plug

Post by hykez87 »

gemt wrote:Looks good!
I can't help thinking that if I could think of the right bottle then cut the bottom off it,
then you could put the thread on the outside, have more depth on the inside, and use the screw top to close.
Perhaps some cosmetic pot?
That could work, but it might be more expensive though.
Post Reply